T-Braid
1) Use a light wire to tie off flattened T-Braid to bare exhaust pipe at starting position.
2) Firmly wrap flattened T-Braid, edge to edge in a spiral pattern along exhaust pipe. Do NOT overlap.
3) Tie off the trailing end of the T-Braid to hold in place.
*Insulation applied directly to bare exhaust

Pyro-Tape
1) Tie off end of Pyro-Tape at starting point of T-Braid.
2) Firmly wrap Pyro-Tape, edge to edge in a spiral pattern, covering the T-Braid. You shouldn’t have to overlap, but if overlapping
is required, overlap by at least 1/2″ to prevent slipping.
3) Tie off the trailing end of the Pyro-Tape to maintain tightness and to prevent unraveling.
*Do not apply directly to bare exhaust pipe
*Protective insulating cover applied directly over T-Braid

PLT-310
1) Apply to seam of Pyro-Tape and smooth out with a damp cloth ensuring complete sealing of spiral edges.
2) Allow PLT-310 proper curing time, of approximately 1 hour, before putting exhaust pipe back into service.
*Do not apply directly to bare exhaust pipe
*Silicone sealant to prevent fluids from entering insulation
CAUTION: Do not apply Pyrotape or Pyrosealant directly to the bare pipe, as this could create a fire.